If the font has a UPM of 1600 and each pixel is 100x100 units, then the nominal font size is 16 pixels (1600/100=16). The size of the em square can be set from Element > Font Info then click on the General tab and you will see the EM setting, which value shall be. Does anyone know how to make and use an FF Inkscape template I see they have a way to save as SVG template, but I haven't figured it out. You need to pick an EM size (I chose 1000), and set your page size as well as set the Viewbox to 0,0,1000,1000 for FF. Or, if you're going to the trouble of installing a font editor like FontForge to open up the font, you will need to measure a pixel and find out the UPM (units per em) of the font. Set a base guideline, then ascent and descent guides, width guides, etc. In a 6point font, 1 em equals 6 points in a 10point font, 1 em equals 10 points. Then use whatever app you're using to display the font and increase the font by one pixel at a time until it suddenly has sharp edges as all the pixels in the font line up with the pixels on your screen. em, a unit of measure that is relative to the current type size. In TrueType fonts, the UPM is by convention a power of two, generally set to 1024 or 2048. The nominal size will be at least that amount, but often will be a few pixels taller if the font includes letters with accents. UPM or em size is usually set at 1000 units. First, count the total height of a capital letter like X, then add any additional pixels that hang below the baseline in lowercase letters like g or p. That means the Catamaran font uses 1100 + 540 units in a 1000 units em-square, which gives a height of 164px when setting font-size: 100px. Setting it will change the encoding used for indexing: familyname: PostScript font family name: fondname: Mac fond name: fontname: PostScript font name. encoding: The name of the current encoding. Setting this will scale the entire font to the new size. Usually the easiest way to figure out the "nominal size" of a pixel font is by trial and error. Size (in pica points) for which this font was designed. When I use this merged font in photoshop, and set font-size to 56px. So that in the same font-size, one font will bigger than the another. "Nominal size" in that article is referring to the font size for a pixel font where the "pixels" in the font (they are actually vector outlines) line up perfectly with the pixels on your screen. For 'different font-size', I change the Em-size of font-info. These can be set with Element->FontInfo->OS/2, but are usually allowed to default to the Ascent and Descent values of FontForge they generally sum to 1em and.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |